Wireless Access

Occasional Contributor I

Need help for my AP274 Point-to-Point setup

I have an on going project that has two trailers, each with an Aruba 7005 controller but only the first trailer will have the VPN tunnel going back to corporate network, so I'm going to setup a Poin-to-Point link between two trailers. Please see attached file. Basically, I have 4xAP274.

1. So, how do I configured them?

2. What is the role for each AP?

3. Please see the attached file, should I patch AP2 and AP3 using an ethernet cable?


Thanks in advance.

Re: Need help for my AP274 Point-to-Point setup

Have a look at the point to point guide here as it explains how to configure your APs.


Yes, to achieve what you want in your diagram you would attach AP2 and AP3 with an Ethernet cable.


ACCX #540 | ACMX #353 | ACDX #216 | AMFX #11

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Search Airheads
Showing results for 
Search instead for 
Did you mean: