The AP367 seem to be excellent to build a P2P link.
Software = 6.5.x
The setup seems to be easy:
- connect both to one Switch
- configure SSID
- disable extended SSID
- Configure ETH0 for bridge on the second AP 367
After that mesh is working, but the second AP 367 doesn`t bridge packet to ETH0
With no VLANS:
in this mode (no trunk) the second AP 367 always disables the ETH0 and no traffic can pass
With a TRUNK (more important):
if you configure a trunk with wired profile, ETH0 is not disabled, but no traffic / no mac addresses are visible on the switch where ETH0 is connected.
Here my wired profile:
wired-port-profile P2P-Trunk
switchport-mode trunk
allowed-vlan 104
native-vlan 106
trusted
no shutdown
access-rule-name P2P-Trunk
speed auto
duplex auto
poe
type employee
auth-server InternalServer
captive-portal disable
no dot1x
Can anyone share a working config with me?
What could be the problem?
Thanks in advance