Thank you for the reply.
According to the guide, I should be able to write the command "ids dos-profile <profile-name>"
But on my controller, working in CLI mode, I don't have this option.
The only available commands to me are:
(Controller) (config) #ids ?
general-profile Configure an IDS General Profile
profile Configure an IDS Profile
rap-wml-server-profile Configure an IDS RAP WML Server Profile
rap-wml-table-profile Configure an IDS RAP WML Table Profile
unauthorized-device-p.. Configure an IDS Unauthorized Device Profile
wms-general-profile Configure the IDS WMS General Profile
wms-local-system-prof.. Configure the IDS WMS Local System Profile
Is there a feature I need to enable or something in order to get the "dos-profile"?