Rebooting AP275 and Uplink VLAN?
04-30-2015 11:40 AM
I opened a TAC case for a constantly rebooting AP275. It cycles every 11 or 12 minutes - show an ID flag then appears to reboot. Lather, rinse, repeat.
TAC wants me to attach a console cable. Which is a pain, because this is up a pole in a public area.
While I am waiting for an opportunity to grab it, I did the "what's different about this one?" game. I have 80 275's operating well.
So it turns out, it seems, that Uplink VLAN may be the culprit. I have all of my WiFi gear communicating with the controller across VLAN114. The controller hands out DHCP for this VLAN, and the misbehaving one has been getting a proper assignment. But (perhaps in an effort to fix a problem, I forget) this AP is set to Uplink VLAN 114. My other AP's are set to Uplink = 0.
I went into the switch port for this AP and untagged it to VLAN 1, and it has been up and not rebooting for a few hours. If has an IP address off of my default VLAN, so it's not a permanent fix.
So my question is, what should Uplink VLAN be set to, when the switch you are connecting to has the port untagged for VLAN 114?
Re: Rebooting AP275 and Uplink VLAN?
04-30-2015 11:42 AM
*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Learning Videos
Aruba Central Documentation
ArubaOS Consolidated Release Notes
Aruba Technical Webinars