Wireless Access

last person joined: 23 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

S2500 will not load

This thread has been viewed 2 times

  • 1.  S2500 will not load

    Posted Jan 14, 2014 01:27 PM

    S2500POE will not boot into AOS. LCD stuck on "Aruba" in LCD, no buttons accessible either.  The switch is in a stack.  Have removed it from the config and it still will not come up.



  • 2.  RE: S2500 will not load

    EMPLOYEE
    Posted Jan 14, 2014 01:50 PM
    Justchantelle,
    I recommend opening up a TAC case.

    Out of curiosity, when it was removed from the stack, did you get anything from the console?

    Best regards,

    Madani


  • 3.  RE: S2500 will not load

    Posted Jan 14, 2014 02:00 PM

    It was removed from the stack this morning and it never changed.  The console is just stuck at the "Aruba" screen that comes before "booting into...".  The buttons will not allow me to go into the menu at all.

     

     



  • 4.  RE: S2500 will not load

    Posted Jan 14, 2014 02:48 PM

    Did you change in the console properties? (Using putty or Hyper Terminal) Make sure under Flow Control select "None"

     

     Capture2.PNG

     

    If you keep the configuration on hardware you are going to get the error below which I assume is the " ARUBA" screen..

     

    Capture44.PNG

     

    After you change the configuration you will see the regular menu..

     

    Capture55.PNG

     

    Regards,

     

    Giovanni Saldarriaga