Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Setup a second virtual ap

This thread has been viewed 1 times

  • 1.  Setup a second virtual ap

    Posted Feb 25, 2014 01:37 PM

    I am trying to setup a second Virtual AP with internet access that is isolated from the default ap and guest ap. I have one setup but it has no internet access.

     

    VLAN 1 is my default, VLAN 900 is the guest, and VLAN 2 is the new one.

     

    VLAN ID   IPv4 Address         IPv4 Net Mask   IPv6 Address              Associated Ports    AAA Profile Admin State Operation State Mode  

    110.250.250.200255.255.0.0fe80::b:8600:16d:ff58 GE1/0-3,Pc0-7N/AEnabledUpRegular 
    2172.16.0.1255.255.252.0fe80::b:8600:26d:ff58  N/AEnabledUpRegular 
    900192.168.200.1255.255.252.0fe80::b:8603:846d:ff58  N/AEnabledUpRegular 

     

    Default Router 10.250.250.200

    DNS Servers 10.250.250.66 10.250.250.67

    Network  IP Address 10.250.200.0 Net Mask 255.255.248.0

     

    Default Router 192.168.200.1

    DNS Servers 208.67.222.222 208.67.222.220

    Network  IP Address 192.168.200.0 Net Mask 255.255.252.0

     

    Default Router 172.16.0.1

    DNS Servers 208.67.222.222 208.67.222.220

     

    Network  IP Address 172.16.0.0 Net Mask 255.255.252.0

     

    What am I doing wrong? Is there a better way to isolate these devices?



  • 2.  RE: Setup a second virtual ap

    EMPLOYEE
    Posted Feb 25, 2014 01:51 PM

    Not sure what you are trying to do.  What is the business issue you are trying to solve?



  • 3.  RE: Setup a second virtual ap

    Posted Feb 25, 2014 02:25 PM

    We have wifi devices for streaming content for digital sinage but need to keep users off of them. Unfortunately they do no have authentication. So I was hoping to just isolate them on their own SSID and VLAN.



  • 4.  RE: Setup a second virtual ap

    EMPLOYEE
    Posted Feb 25, 2014 02:39 PM

    What isn't working?  I noticed you have no physical interfaces applied to this new VLAN



  • 5.  RE: Setup a second virtual ap

    Posted Feb 25, 2014 02:53 PM
    After connecting to that network there is no internet access like there is on the guest network.

    I don't have vlans setup on my wired network. Eventually I will but I don't want the aruba dhcp on the wired.


  • 6.  RE: Setup a second virtual ap
    Best Answer

    Posted Feb 25, 2014 03:07 PM

    Is the controller going to act us a default-gateway for clients on VLAN 2?

     

    if VLAN1 is the only routable one, then you may need to src-nat the traffic like below.

     

    Conf t

    Interface vlan 2

    ip nat inside

    write memory

     

    Test the client again.



  • 7.  RE: Setup a second virtual ap

    Posted Feb 25, 2014 04:18 PM

    Thanks,

     

    That was the problem.