Here's the scenario. I have a few pieces and parts for testing and learning set up in my house. My current set up is as follows.
Controller - 620-US
AP'S
AP-105 powered by PoE from the controller and set as a mesh portal.
AP-125 Powered by PD-9001G-AZ PoE+ injector set as a mesh point.
Problem:
I can't seem to get ENET1 to function so I could say use it to connect my Ethernet capable blu-ray or a network printer in the other room. I've attached screen shot of my wired AP profile.
I have both AP's in the same group and under the same profile, is that my problem or am I missing something else that is obvious to the more experienced Aruba masters in this community?
Any assistance is greatly appreciated.
Thanks,
Jgilb