Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

UN-provisioing

This thread has been viewed 2 times

  • 1.  UN-provisioing

    Posted Sep 27, 2012 11:48 AM

    I'm still new in Aruba land.  How do I un-provision an AP on a 3200XM so I can provision it on the backup controller?  Found lots of instruction on how to provision but not unprovision. 

     

    Thanks,

    Dennis

     


    #3200


  • 2.  RE: UN-provisioing

    Posted Sep 27, 2012 04:31 PM

    Just provision it to the new one. I usually move them around by using the Host Controller IP Address field on the AP provision page.

     

    I guess you could also completely reset the AP by using the console to do a clearenv. You can even tell it where to go when it boots next by using setenv commands directly to the AP console. But the first way should be just fine.



  • 3.  RE: UN-provisioing

    Posted Sep 27, 2012 07:18 PM

    Are you using redundancy or are you using master and local config?

    What do you mean with backup controller?