Wireless Access

Reply
Highlighted
Contributor II

Viewing AP Group settings from the AP

Dear Experts, 

 

When we change any setting in AP Group, such as lms-ip/backup-lms ip, is there anyway to see it from the AP itself if console is enabled? can anyone share the command for it?

Guru Elite

Re: Viewing AP Group settings from the AP

On the commandline of the controller you would type:

 

show ap config ap-name <name of ap>

That will tell you what configuration is applied to that access point. 


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.4 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Aruba Central Documentation
Sign up for Security Alerts
Aruba Technical Webinars
Contributor II

Re: Viewing AP Group settings from the AP

Dear Colin, 

 

Thanks for the prompt response. Out of curiosity, is there anyway to check from the console of AP itself?

Guru Elite

Re: Viewing AP Group settings from the AP

Some parameters, yes, but the the information from the console is typically for engineering (undecipherable) and scattered all over the place.  Is there a problem with viewing it on the controller?


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.4 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Aruba Central Documentation
Sign up for Security Alerts
Aruba Technical Webinars
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: