Wireless Access

last person joined: 10 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

WLC7030 - loop on boot

This thread has been viewed 8 times

  • 1.  WLC7030 - loop on boot

    Posted Jun 23, 2020 08:40 AM

    Hi team!!!

    After format 7030 in release 6.5.4.6 , each time the controller boots show me the initial setup:

    Starting auto provisioning
    Using port gigabitethernet 0/0/7 for auto provisioning
    Initiated DHCP, awaiting DHCP response

    Auto-provisioning is in progress. Choose one of the following options to override or debug...
    'enable-debug' : Enable auto-provisioning debug logs
    'disable-debug' : Disable auto-provisioning debug logs
    'mini-setup' : Stop auto-provisioning and start mini setup dialog for branch role
    'full-setup' : Stop auto-provisioning and start full setup dialog for any role


    After completed as "master" the controller reboots itself and returns to the same stage.

     

    Any idea?

     

    Regards

     

    EF

     

     



  • 2.  RE: WLC7030 - loop on boot
    Best Answer

    EMPLOYEE
    Posted Jun 23, 2020 09:29 AM

    That could be because your cfgfile environment variable is set to something other than default.cfg.  See the article here:  https://community.arubanetworks.com/t5/Controller-Based-WLANs/How-do-I-use-the-controller-boot-parameter-cfgfile-to-recover/ta-p/177922 on how to recover it.

     

    tl;dr:

     

    at the cpboot prompt, set your cfgfile variable to default.cfg, save then boot to see if that fixes it.