Wireless Access

Reply
Regular Contributor II

Web Interface to the controller stopped but can get to it via SSH

This morning I tried to access the controller (6000 with M3 card), but I could not open the web interface to it. I am able to ping it and SSH to it. We are running 6.3.1.2 AOS. Is there a service(s) to restart without restarting the whole controller?

Guru Elite

Re: Web Interface to the controller stopped but can get to it via SSH

process restart httpd


Thanks,
Tim

| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Regular Contributor II

Re: Web Interface to the controller stopped but can get to it via SSH

Thanks Tim.

TAC called back and found that for some reason the Enable WebUI access on HTTPS port (443) was set to false. TAC looked and did not see why it changed to false since no configuration change was made.

Occasional Contributor I

Re: Web Interface to the controller stopped but can get to it via SSH

I know i'ts an old post... could you please exlpain hot to enable webui access on https port? 

MVP Guru

Re: Web Interface to the controller stopped but can get to it via SSH

By default the Web interface is enabled via TCP4343, if you need to change this to HTTPS (TCP443) use the following:

 

(Aruba7030) *[mynode] (config) #web-server profile
(Aruba7030) *[mynode] (Web Server Configuration) #
(Aruba7030) *[mynode] (Web Server Configuration) #web-https-port-443

ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Occasional Contributor I

Re: Web Interface to the controller stopped but can get to it via SSH

thnx Craig for the quick answer

 

but my problem remains.

I can't get to the webui of my Dell  powerconnect w3200 controller.

 

I can get to the controller through ssh

Re: Web Interface to the controller stopped but can get to it via SSH

Might be high cpu usage?

did u enable some extra logging on the controller? (try to disable them)

please send us cpu usage output from cli.

 

 

*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************
Occasional Contributor I

Re: Web Interface to the controller stopped but can get to it via SSH

(Master-Aruba) #show cpuload

user 1.2%, system 0.7%, idle 98.1%

 

 

it looks ok

 

I was able to connect to the webui using firefox but I didn't login using the same user used throuch ssh

 

thanks a lot

 

Web Server Statistics:
----------------------

Current Request Rate: 1 Req/Sec
Current Traffic Rate: 0 KB/Sec
Busy Connection Slots: 1
Available Connection Slots: 24
Total Requests Since Up Time: 1
Total Traffic Since Up Time: 0 KB
Avg. Request Rate Since Up Time: 0 Req/Sec
Avg. Traffic Rate Since Up Time: 0 Bytes/Sec
Server Scoreboard _W_______________________

 

Occasional Contributor I

Re: Web Interface to the controller stopped but can get to it via SSH

after several minutes I was able to see the login :)

 

 

I'll try to login again and wait...

 

the controller is working perfectly we have about 80 clients

Occasional Contributor I

Re: Web Interface to the controller stopped but can get to it via SSH

controller is working but no webui. I think I'll restore a previous config

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: