Hi,
I was checking at the desing guide, and I can see that when I have Master-Local controller model, I can use VRRP to be able to redirect the APs to the active controler when in the same layer 2 network. Do I need only to tell the Local controller the role, add the Master IP, and configure VRRP, and then Check the locals controllers on the master and then configure the VRRP. Steps are not complete clear on the configuration guide:
l Configure the interface on the master controller to be a trunk port with 1, 2… n being member VLANs.
l Collect the following data before configuring master controller redundancy.
l VLAN IDs on the controllers corresponding to the VLANs 1, 2…n shown in the topology above.
l Virtual IP addresses that has been reserved to be used for the VRRP instances.
l You can use either the WebUI or CLI to configure VRRP on the master controllers (seeTable 106 ). For this
topology, the following are recommended values:
l For priority: Set the local to 110; set the master to 100 (the default value)
l Enable preemption
I know that LMS IP needs to be set up for each AP with the Virtual IP fo VRRP.
Can I have a CLI example of this configuration?
How should be the procedure when local controller is in another subnet?
Thanks in advance