Wireless Access

I recently upgraded Partition 1 to 6.1.2.6 following the proper procedure and with the correct amount of memory and storage. I am now trying to reboot the controller to Partition 1 but it will not take. I have set the boot partition and restarted inside the GUI and from the CLI. Any ideas or suggestions would be greatly appreciated.

When you say it will not "Take" what are the steps you take and what happens?

As I mentioned in my post, after upgrading Partition 1, I set the default boot partition to Partition 1 and rebooted. The controller 

continues to boot to Partition 0. I have tried these steps both in the GUI and in CLI. It was at a proper previous version to make the 

upgrade and there was enough memory and storage for the upgrade. Any ideas?

- What controller platform is this?

- What are you upgrading from?

- What method are you using to upgrade and did it finish?

When you upgrade a partition, the boot partition is automatically set to that partition, so you should only have to reboot to switch to that code.

-3400

-6.0.1.3

-FTP and it finished successfully

Yeah usually it does switch to the partition you upgrade, but in this instance it did not. So I manually set it. Could that mean there is an issue with that partition? Should I upgrade or downgrade to a different version and try again?

What are you upgrading from?

You should type "show image version" to make sure the upgrade was successful.  The console log on the controller will also tell you if there are problems during bootup.

Please refer to previous post! Upgraded from 6.0.1.3.

This is the current image versions of the controller:

(CO-W3400-MDF-01) #show image version
----------------------------------
Partition : 0:0 (/dev/hda1)
Software Version : ArubaOS 6.0.1.3 (Digitally Signed - Production Build)
Build number : 28554
Label : 28554
Built on : Tue May 31 14:53:42 PDT 2011
----------------------------------
Partition : 0:1 (/dev/hda2) **Default boot**
Software Version : ArubaOS 6.1.2.6 (Digitally Signed - Production Build)
Build number : 31653
Label : 31653
Built on : Fri Dec 23 16:56:44 PST 2011

When you reboot, you should capture the console logs to see if anything is amiss.  If that does not work, please open a case with support.

I will try to get out to that controller today and do this. Thanks for your help.

Upgraded Partition 1 again only this time through a console connection. Upgrade was successful. Rebooted controller to Partition 1 successfully. Got to love the GUI; sometimes it works and other times not so much. Thanks again for your help.

Sorry, wrong topic