Wireless Access

Reply
Highlighted
Regular Contributor II

ap 360 mesh link for bridging

Hi all

 

I am struggling with a mesh link done with two Aruba outdoor 367.

 

We have instant OS 6.5.4.3 version.

The focus is to connect a main bulding to a remote bulding that does not have wired installed.

 

So I have set up a Mesh link between Main building ( mesh portal) and remote bulding ( mesh point). 

I can ping the mesh portal from the mesh point with very good measures.

Also enabled SSid  for a testing vlan and it works good.

 

Next step is to deliver wired to the remote site. I read that I need to enable enet0 bridging on mesh point and also check wired profile settings for put it up.

 

Is this what I need to get main office wired network delivered via the mesh link?

Also, is it possible to enable trunk on the ports f the switch and for wired profile to pass more vlans to remote site?

 

Thanks

 

regards 

Regular Contributor II

Re: ap 360 mesh link for bridging

Hi 

 

any help on this??

Guru Elite

Re: ap 360 mesh link for bridging

Regular Contributor II

Re: ap 360 mesh link for bridging

Hi

 

going to finish this config tomorrow. 

 

Already have the link working via wireless. This is a 4,5 km link.

 

The next step to connect to lan switching ( trunk with vlans) is to do the config of wired profile on both antenas correct? 

 

Regards

Regular Contributor II

Re: ap 360 mesh link for bridging

Hi 

 

Should Enet0 bridging be enable??

 

 

Frequent Contributor I

Re: ap 360 mesh link for bridging

yes

 

in your wired ap profile:

forward mode : bridge

 

set switchport mode to trunk  - if you want to pass vlan tags over link

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: