Wireless Access

Hi all

I am struggling with a mesh link done with two Aruba outdoor 367.

We have instant OS 6.5.4.3 version.

The focus is to connect a main bulding to a remote bulding that does not have wired installed.

So I have set up a Mesh link between Main building ( mesh portal) and remote bulding ( mesh point). 

I can ping the mesh portal from the mesh point with very good measures.

Also enabled SSid  for a testing vlan and it works good.

Next step is to deliver wired to the remote site. I read that I need to enable enet0 bridging on mesh point and also check wired profile settings for put it up.

Is this what I need to get main office wired network delivered via the mesh link?

Also, is it possible to enable trunk on the ports f the switch and for wired profile to pass more vlans to remote site?

Thanks

regards 

Hi 

any help on this??

https://community.arubanetworks.com/t5/Video/Instant-Training-Module-7-Mesh-Wired-Access-amp-Uplink/ta-p/289926

Start at 5:49

Hi

going to finish this config tomorrow. 

Already have the link working via wireless. This is a 4,5 km link.

The next step to connect to lan switching ( trunk with vlans) is to do the config of wired profile on both antenas correct? 

Regards

Hi 

Should Enet0 bridging be enable??

yes

in your wired ap profile:

forward mode : bridge

set switchport mode to trunk  - if you want to pass vlan tags over link