Wireless Access

last person joined: 19 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

cannot get RF Protect licenses to work on a local controller

This thread has been viewed 0 times

  • 1.  cannot get RF Protect licenses to work on a local controller

    Posted Dec 19, 2013 12:57 PM
      |   view attached

    Hello everyone, this is my first post so here it goes.

    Environment is one master and 38 locals.

    We would like to start using Spectrum Monitoring.

    Purchased 10 RF Protect licenses. Installed 2 of the licenses on a local controller.

    Results after rebooting the controller was that the controller only saw the first 2 APs

    I have setup an ap group for spectrum monitoring that is working on the master controller thanks to Marko, but can't get them to work on the local.

    Thanks in advance

     

    Attachment(s)

    docx
    Bert Church RFP Licenses.docx   377 KB 1 version


  • 2.  RE: cannot get RF Protect licenses to work on a local controller

    EMPLOYEE
    Posted Dec 19, 2013 01:20 PM

    The licences must all be equal. 

     

     

     



  • 3.  RE: cannot get RF Protect licenses to work on a local controller

    Posted Dec 19, 2013 01:47 PM

    RF licenses have to equal ap licenses?



  • 4.  RE: cannot get RF Protect licenses to work on a local controller

    EMPLOYEE
    Posted Dec 19, 2013 01:49 PM

    Yes. Licensing uses the lowest license count.



  • 5.  RE: cannot get RF Protect licenses to work on a local controller

    Posted Dec 19, 2013 01:59 PM

     

     

    Thanks for your responses this has helped me figure out how to get spectrum monitoring up and running.