Wireless Access

I keep seeing the following message on my console connection to my Aruba AP-225 connected to my 7210 controller, running 6.3.1.16: "firewall: dev br0/11 not in vlan 1"

I also have a AP system profile setup to connect the AP to a local controller vs the master:

topology as follows:

Master<---vrrp----->Master(stdby)

        |                               |

CISCO   PoE SWITCHING

       |                                |

Local-1                      Local-2

Also, the AP seems to keep rebooting

Error as Follows:

[  595.695687] firewall: dev br0/11 not in vlan 1
[  595.753758] firewall: dev br0/11 not in vlan 1
[  595.808343] firewall: dev br0/11 not in vlan 1

I have just rolled back all the controllers to 6.1.3.15 and will look for the same behavior.

Fortunately this is not a live environment.

That log message should be cosmetic and should be fixed in 6.4.3.x.  You need to find out if there is another reason why your access point is rebooting.  If there is no other reason, you should open a TAC case.

I just rolled back my controllers to 6.1.3.15 and the error/issue has stopped.

I have purged and erased the AP, reprovisioned to no effect, downgrading to the 6.3.1.15 from 6.3.1.16 did the trick.

I dont think having your APs reset and kicking users off is a cosmetic issue, also we are still running AP 61s going to 6.4.x is not an option.

Are users being kicked off?  You did not mention that.  If you are facing those issues, you should open a TAC case.  Also, if the AP is being reset, you should open a TAC case, as well.  

I can only tell you that specific message is cosmetic.  A tac case would be required to sort anything else out.

No I stated this is not a live environement, I discovered this by accident, luckily before I upgraded our M3's that are live,