Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

modulation used by client transmit power control and AP usage

This thread has been viewed 1 times

  • 1.  modulation used by client transmit power control and AP usage

    Posted May 03, 2014 02:22 PM

     

    We are doing testing for Multicast over wireless ( without DMO) need help understanding below points

     

    1. Can we check the current modulation type the client is using ? ( MCS index or something similar)

    2.Usage details of AP / radio . Specifically from CLI.

    3. Is automatic transmitt power control is available for both uplink and downlink?

     

     



  • 2.  RE: modulation used by client transmit power control and AP usage
    Best Answer

    EMPLOYEE
    Posted May 03, 2014 02:28 PM
    @newbie wrote:

     

    We are doing testing for Multicast over wireless ( without DMO) need help understanding below points

     

    1. Can we check the current modulation type the client is using ? ( MCS index or something similar) - A wireless packet capture is the most accurate means to reveal the MCS rate of every frame.  Anything on the controller will just be a snapshot in time MCS (statistics might only be updated every 60 seconds).

     

    2.Usage details of AP / radio . Specifically from CLI. - show ap debug radio-stats ap-name <name of ap> radio 0 advanced should give you all the radio stats of the AP.

     

    3. Is automatic transmitt power control is available for both uplink and downlink? - Please be more specific