Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

strange discrepancy in lacp bundle

This thread has been viewed 3 times

  • 1.  strange discrepancy in lacp bundle

    Posted Dec 17, 2018 09:39 AM

    I have created an LACP trunk on a 7210 controller running aruba os 8.3.0.4 using ten gig sfp modules

     

    In the text view of the config both ports are identical, but in  the gui view I have both ports with native vlan 1, but I see  access vlans 1 and 10ScreenShot001.jpg

    port configport configlacp trunklacp trunk

    ScreenShot004.jpg

    every config change results in an error message :
    "Illegal operation: Interface belongs to a port channel group"

    even when i modify unused interfaces in shutdown mode

     

    any clue what's going on ?



  • 2.  RE: strange discrepancy in lacp bundle

    Posted Dec 17, 2018 10:02 AM
    Remove the interface of the LACP group first and then make the change

    Sent from Mail for Windows 10


  • 3.  RE: strange discrepancy in lacp bundle

    Posted Dec 17, 2018 10:24 AM

    I have removed the interface g 0/0/2 holding vlan 10 from the bundle.

    But there is no place vlan 10 shows in the config of that interface

    g 0/0/2 removed from trunkg 0/0/2 removed from trunkconfig of g 0/0/2config of g 0/0/2



  • 4.  RE: strange discrepancy in lacp bundle

    Posted Dec 17, 2018 10:49 AM
    Sorry but don’t quite understand what are you trying to accomplish

    You can check what configuration have been applied to MC by running the show configuration effective | include vlan command from the MM /folder the MC was assigned to





    Thank you

    Victor Fabian

    Pardon typos sent from Mobile


  • 5.  RE: strange discrepancy in lacp bundle

    Posted Dec 18, 2018 02:55 AM

    Victor

    Thanks for the time you spend here.

    Let me explain my activities.

    The controller was connected to an IRF stack of H3C switches using two 1g links. They used ports g0/0/0 and g0/0/1 on the controller and showed as PC1
    A new stack of switches win TenGig Interfaces was installed, and I created a lacp bundle PC2 using interfaces g0/0/2 and g0/0/3. I created the PC2 trunk wit its switchhports shut, and for migration i Shut the switchports of PC1 and unshut the ones for PC2.

    Everything was fine. A few days later the troubles began showing the error messages from above. I have not been onsite last week, So I cannot tell what happened in detail. but the discrepancy in the config of the two trunk members is obvious.

    I will run the command you recommended when I am back onsite and report the output.

    Cheers

     

    Albert



  • 6.  RE: strange discrepancy in lacp bundle

    Posted Dec 18, 2018 04:20 AM

    Victor

     

    Running "show configuration effective" shows interface g 0/0/2 as shutdown.

     

    But show interface g 0/0/2 shows it up/up

    strange ....sh conf effectivesh conf effective