Wireless Access

Reply
Highlighted
New Contributor

uploading controller config data to new mobility master

We had an outside firm set up a pair of 7205 controllers to manage the WiFi network and that has been working without issue. They then set up a mobility master that can see the controllers, all APs and clients. When I recently went to provision a new AP, I discovered that none of the AP groups were available to select from so the WLANs can't push out to the new AP.

 

Upon further inspection, I found that WLAN, group, and a great deal more information appears to only be available on the controllers. And I don't have the ability to provision new APs on the controllers.

 

How do I get the controllers to "upload' all information to the mobility master so I can do all the management at that level?

 

Thanks in advance!


Accepted Solutions
Highlighted
Super Contributor II

Re: uploading controller config data to new mobility master

Dustin-Burns_0-1600200816941.png

 

Dustin-Burns_1-1600200824968.png

 

Dustin-Burns_2-1600200832218.png

 

 

Dustin Burns
Senior Mobility and Access Engineer @WEI
ACMX #509 | ACCX #1272 | ACSA | ACDA | ACEA | CCNP | CCDP | CCNA Wireless

If my post address your queries, give kudos and accept as solution!

View solution in original post


All Replies
Highlighted
Super Contributor II

Re: uploading controller config data to new mobility master

When logged into the Mobility Master do you see a configuration structure like the image attached and inline? Your Configuration would take place under the Managed Network section, most likely in the next folder down like you see on mine as Home-Lab.

Dustin-Burns_0-1600200511577.png

 

Dustin Burns
Senior Mobility and Access Engineer @WEI
ACMX #509 | ACCX #1272 | ACSA | ACDA | ACEA | CCNP | CCDP | CCNA Wireless

If my post address your queries, give kudos and accept as solution!
Highlighted
Super Contributor II

Re: uploading controller config data to new mobility master

Dustin-Burns_0-1600200816941.png

 

Dustin-Burns_1-1600200824968.png

 

Dustin-Burns_2-1600200832218.png

 

 

Dustin Burns
Senior Mobility and Access Engineer @WEI
ACMX #509 | ACCX #1272 | ACSA | ACDA | ACEA | CCNP | CCDP | CCNA Wireless

If my post address your queries, give kudos and accept as solution!

View solution in original post

Highlighted
New Contributor

Re: uploading controller config data to new mobility master

Yes, I do see the structure like you show there. I still am unable to choose those AP groups when provisioning new APs through the mobility master, however.

Highlighted
New Contributor

Re: uploading controller config data to new mobility master

I was able to browse to the controller group and when I selected this, then tried provisioning the AP again, I was able to select the required AP group. Now all the WLANs are showing as allocated on the new AP.

 

I am all set, thanks!

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: