Wireless Access

Reply
Highlighted
Occasional Contributor I

what does AP flag "f" mean?

Hi, 

I saw ap shows a flag "f" , but there is no explaination.

Could you tell me what does it mean?

 

iShot2020-03-1021.29.25.png

 


Accepted Solutions
Highlighted
MVP Guru

Re: what does AP flag "f" mean?

It means there is no Spectrum FFT support. Take a look at the 'show ap database' output for more info.

 

 

Flags: 1 = 802.1x authenticated AP use EAP-PEAP; 1+ = 802.1x use EST; 1- = 802.1x use factory cert; 2 = Using IKE version 2
       B = Built-in AP; C = Cellular RAP; D = Dirty or no config
       E = Regulatory Domain Mismatch; F = AP failed 802.1x authentication
       G = No such group; I = Inactive; J = USB cert at AP; L = Unlicensed
       M = Mesh node
       N = Duplicate name; P = PPPoe AP; R = Remote AP; R- = Remote AP requires Auth;
       S = Standby-mode AP; U = Unprovisioned; X = Maintenance Mode
       Y = Mesh Recovery
       c = CERT-based RAP; e = Custom EST cert; f = No Spectrum FFT support
       i = Indoor; o = Outdoor; s = LACP striping; u = Custom-Cert RAP; z = Datazone AP
       p = In deep-sleep status
       4 = WiFi Uplink
       r = Power Restricted; T = Thermal ShutDown

 

 

 


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)

View solution in original post


All Replies
Highlighted
MVP Guru

Re: what does AP flag "f" mean?

It means there is no Spectrum FFT support. Take a look at the 'show ap database' output for more info.

 

 

Flags: 1 = 802.1x authenticated AP use EAP-PEAP; 1+ = 802.1x use EST; 1- = 802.1x use factory cert; 2 = Using IKE version 2
       B = Built-in AP; C = Cellular RAP; D = Dirty or no config
       E = Regulatory Domain Mismatch; F = AP failed 802.1x authentication
       G = No such group; I = Inactive; J = USB cert at AP; L = Unlicensed
       M = Mesh node
       N = Duplicate name; P = PPPoe AP; R = Remote AP; R- = Remote AP requires Auth;
       S = Standby-mode AP; U = Unprovisioned; X = Maintenance Mode
       Y = Mesh Recovery
       c = CERT-based RAP; e = Custom EST cert; f = No Spectrum FFT support
       i = Indoor; o = Outdoor; s = LACP striping; u = Custom-Cert RAP; z = Datazone AP
       p = In deep-sleep status
       4 = WiFi Uplink
       r = Power Restricted; T = Thermal ShutDown

 

 

 


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: