Wireless Water Cooler

last person joined: 16 days ago 

Hang out and socialize with other community members in this off topic forum. Everything from industry trends to hobbies and interests are welcomed!
Back to discussions
Expand all | Collapse all

AP-135 bond

This thread has been viewed 0 times

  • 1.  AP-135 bond

    Posted Jun 19, 2014 05:15 PM

    Hello

     

    Is it possible to bond the interfaces on an AP-135 for ethernet redundancy, or to achieve over 1Gbps throughput?

     

    So far it appears not, but I am looking for confirmation. 

     

    Thanks!



  • 2.  RE: AP-135 bond

    EMPLOYEE
    Posted Jun 19, 2014 06:36 PM

    Honestly, the AP135 cannot negotiate WLAN rates to push more than a gig of WLAN traffic.



  • 3.  RE: AP-135 bond

    Posted Jun 19, 2014 07:45 PM
    Thanks for the response! looks to me like it would top out at 900Mbps. Do
    you happen to know if network (not just power) redundancy is possible?


  • 4.  RE: AP-135 bond

    EMPLOYEE
    Posted Jun 19, 2014 07:48 PM

    If the AP135 is plugged into 2 poe switches, it will take power from one. If the link on that interface goes down, the whole access point reboots and could be powered by the second switch.  That would be like a two to three minute outage.  Very few deploy in this manner.