The on_controllerscommand that's built in to AirWave will ssh into all of your Aruba controllers, issue commands, and report the results to standard output. It can also send the results via email....
Summary : The script on_controllers is used onAirwave servers to run commands on the controller. The output can be emailed directly to your mail id as well
Environment : The s...
Q:
What commands can we execute from limited CLI access
A:
We can login as ampadmin user and select option "11" which is for enter commands,
AirWave Management Platform 8.2.6 on l...
Problem: In custom AMP installation on RHEL, the AMP alias commands may or may not work. If they don't work then you could resolve the issue using the procedure in this article.
Some o...
...tandby mode;
L = Active Load Balancing Enabled; D = Disconn. Extra Calls On; B = Battery Boost On
Num APs:3
Verify: AP Can’t Connect to Controller
(Aruba200) #show ap debug counters ap-n...
...evice. b. Loading or redirecting captive portal page on the client device for guest access. 2. However, sometimes due to controller being busy, the captive portal or Web-UI may not load in t...
Question I am trying to stop and start (or say disable and enable) VisualRF from AirWavecommand line. Can any one please let me know the command or query?
Answer AirWave has a process called S...
...nterface statistics for port A1 on a 5400zl switch.
Normally we would type the command "show interface a1" to view this information:
5400-1_5406zl# show int a1
Status and Counters - Port C...
...bility to SSH into the Airwave as 'root', requiring either direct-console access to shell only, or via a created linux local user account (if this is run over SSH, that access will be lost upon r...
Q: How do you size an Airwave server given your environment?
ASE link: Go to the solution
A: BETA SOFTWARE
Please note this is an Aruba Networks beta solution. Sizing is determined by f...
