Comparing the data seen on Airwave and the Controller, there is a difference of almost 200 clients. Has anyone seen this before where Airwave shows a significantly smaller number of clients?
Hi, in can not search in the tracker for guest sponsor names. Is there another way to trace this info? Is there an existing log to retrieve this information? And for the fu...
- Higher Ed
- Higher Educaction
Hi Sir, I found an AP that uses 12Mbps-54Mbps transmission at most of the time?What factors can affect the data transfer rate？
07-31-2018 01:04 AM
...oweit, aber auf der "HotPage" bzw. auch wenn ich selber eine zusammenstelle werden: Perf Top5, Memory Utilization (%) - Top5, CPU Utilization (%) - Top5 usw. nicht angezeigt bzw. "No data found" a...
Hi, what is different rates in each band Thanks
Show results in replies (5)
Thank you for the reply . It's silly question .Why the same device sending in different data...
Hi, "clients can ignore the data-rates being announced by the access-point and the a...
Hi, Thank you for your great help . I have one question . Why always lower data rates must be d...
...mprove performance, because data at lower rates takes longer to transmit.
Yes, and you will have a problem with that client if that happens. The only way that you woul...
03-15-2019 02:19 PM
...irGroup Info Disabled Inline DHCP stats Enabled Inline AP stats Enabled Inline Auth stats Enabled Inline DNS stats Enabled I rebooted the Controller after i completed the changes but still getting No Data...
05-24-2019 08:27 AM
Hi, We have an AWMS v18.104.22.168 and ALE v22.214.171.124c2 (69768) We have been using the ZMQ feeds from the ALE to provide location analytics data from our backend system. We would l...
02-11-2015 11:51 PM
I have heard there is a new model of controller being released, the 7205. When will the datasheet be available? Or can anyone share what is the max number of AP and users this will be able t...
08-11-2019 09:28 PM
AOS8: currently I go into each VAP/SSID profile and manually tick/untick the data rate boxes for mandatory and supported data rates. Is there a way to set this globally?
Hi: I'm looking to remove the low data rates 1Mbps and 2Mbps, but I'm confused about Basic Rates and Transmit Rates. Right now these rates are checked: 802.11g Basic Rates: 1,2 802.11g Transmit R...
Show results in replies (5)
Your two lowest data rates should be your basic rates. Thanks, Tim
Sorry. Correct as in the same logic is used for the 11a radio. It's best to test the data...
...onfig was correct? Also, no b supported here. What data rates do you recommend for a college campus? &n...
...est different data rates in different buildings, I would need to create a separate ap-group, wlan v...
Your logic is correct. But in reality there is no 11 (1,2), 11b (5.5, 11), 11g (6-54) anymore. Thin...