...ontroller can boot from one of the two partitions. Thepartitions are numbered as 0 and 1.
To change thebootpartition, follow these steps, depending on interface you are using:
U...
...t; console. With IAP, theboot parameter has the configurable option os_partition, which can be used to toggle between OS partitions 0 / 1. For example, setenv os_partition 0 configures the AP to boot...
...hich would bring up the screen as shown and you can select /dev/sdb1/ or /dev/sdb2/ depending upon which partitionyou want to look into.
Note: ClearPass Platform has 2 partition...
Introduction :
This article speaks about changing thebootpartition from Cpboot> mode. use case scenario's where controller get stuck in one bootpartition can be made to boot f...
...ile is stored. cpboot> format 0:2 Format will erase everything on the internal flash's partition 2. Are you sure you want to continue (y/n)?y Formating............................................
Q: How can we switch between thebootpartitions of an IAP via CLI ?
A: We can use the following command to switch between bootpartitions of an IAP:
a) IAP# switch-partition-r...
...partition of member 1.
We get the above message with SSH / consoling into any of the stack members.
1. Why are we getting this message?
2. How can we set thebootpartition...
...bove command, primary runs 4.1.1.2 and backup runs 4.1.1.3. If at any point we want to change thebootpartition of the Instant the below command needs to be executed from CLI. This is not available i...
...SO on theboot prompt type "Linux rescue"
boot: linux rescue
Once done run the below commands for doing an LVM scan if you have used Linux LVM to create your partition
lvm pvscan
lvm v...
...hars): ****** Re-type Password for enable mode: ****** Doyou wish to shutdown all the ports (yes|no)? [no]: Current choices are: System name: Aruba5000 VLAN 1 interface IP address: 172.16.0.254 VLAN 1 i...
