Wireless Access

Who Me Too'd this topic

Frequent Contributor I

clarification on Master Redundancy and Fast Failover

Hi.

Currently I have 2 controllers set for Master Redundancy (active/standby) and Fast Failover (both set as dual) at the same time. In AP profile LMS IP has IP address of active controller and backup LMS IP has IP address of standby controller.

The problem is when I break communication between APs and both controllers for a moment (controllers notice that APs are down) and then restore communication, APs will not reconnect to any controller. I have to reboot APs.

Similar issue is when active controller is down and standby becomes new active then when APs are booted, they will not connect to new active controller.

Is it normal behavior in this setup?

Also can I move some APs (make them active) on standby controller? I think the answer is no but I want to make sure.

Who Me Too'd this topic