PowerShell module is on signature ;-)
You need to look/check the swagger of Mobility Controller (/api if remenber)
and if you want to use powershell module, you need to use PowerArubaMC
------------------------------
PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)
PowerArubaCL: Powershell Module to use Aruba Central
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..
ACEP / ACMX #107 / ACDX #1281
------------------------------
Original Message:
Sent: Jul 22, 2021 11:35 AM
From: Sreekaanth Ganesan
Subject: RAP reboot using API
I went through the github pages for the above you had mentioned like PowerArubaCL etc all four of them. Could not see any reboot endpoint or show ap active equivalent in them.
------------------------------
Sreekaanth Ganesan
Original Message:
Sent: Jul 22, 2021 06:34 AM
From: Alexis La Goutte
Subject: RAP reboot using API
Good question...
do you have look on command stuff ? it is possible ?
------------------------------
PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)
PowerArubaCL: Powershell Module to use Aruba Central
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..
ACEP / ACMX #107 / ACDX #1281
Original Message:
Sent: Jul 15, 2021 09:58 PM
From: Sreekaanth Ganesan
Subject: RAP reboot using API
Hi All,
First time working on Aruba.
TL;DR: I am trying to reboot specific RAP in the Master, the cli command is apboot ap-name <device-name>. How to do it via the API?. The Aruba version is 8.5.
I went through the API doc for 8.5 could not find any reboot RAP api endpoint.
Any help or guidance is appreciated
------------------------------
Sreekaanth Ganesan
------------------------------