Ok, did some testing here as well. Found one controller that had an active crash and needed to do a 'tar crash' first, to remove the * in the prompt. Only after that a 'tar clean crash'. This cleared the alert immediately in the WebUI as well.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Jan 07, 2022 06:29 AM
From: Nikolaj Mikkelsen
Subject: Clear Alert "Crash files available" on MM (VMC) and 7205 controllers.
Hi Herman.
Strangely enough, time was the answer. Getting close to 24 hours the error now is gone.
Kind regards.
------------------------------
Nikolaj Mikkelsen
Original Message:
Sent: Jan 06, 2022 10:42 AM
From: Herman Robers
Subject: Clear Alert "Crash files available" on MM (VMC) and 7205 controllers.
That's the command that I would use. Where do you see that alert? Could it be that it just takes some time before it is cleared?
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
Original Message:
Sent: Jan 06, 2022 04:55 AM
From: Nikolaj Mikkelsen
Subject: Clear Alert "Crash files available" on MM (VMC) and 7205 controllers.
Hi.
How do I clear Alert "Crash files available" on MM (VMC) and 7205 controllers.
Found the "tar clean crash" cli-command and run it on MM (VMC) and both of th controller but it do not looks like it dos anything.
Does anyone know how to clear this alert?
Kind Regards.
------------------------------
Nikolaj Mikkelsen
------------------------------