Wired Intelligent Edge

 View Only
last person joined: 23 hours ago 

Bring performance and reliability to your network with the HPE Aruba Networking Core, Aggregation, and Access layer switches. Discuss the latest features and functionality of your switching devices, and find ways to improve security across your network to bring together a mobile-first solution
Back to discussions
Expand all | Collapse all

2930F JL262A "PoE Fault on Port" & "PoE Controller Selftest Failure" on all ports after power outage.

This thread has been viewed 16 times

  • 1.  2930F JL262A "PoE Fault on Port" & "PoE Controller Selftest Failure" on all ports after power outage.

    Posted Jun 13, 2022 08:07 PM
    Suffered multiple power outages today due to weather, but the UPS in the rack as well as all other equipment never missed a beat, aside from the switch. On power up, all PoE ports are in fault. Reset numerous times, tried different wall and UPS outlets (only has one PSU on board though), but no dice. 

    Any ideas?



    Aruba JL262A 2930F-48G-PoE+-4SFP Switch
    Software revision WC.16.10.0009

    poe_status_port all

    Port 01, Disabled Priority:Lo PowerLimit:0
    Detect Stat: Fault, Class:0 Phy stat: 13
    MPS Absent Ctr: 0 Invalid Sig Ctr: 0 Power Denied Ctr: 0
    OverLoad Ctr : 0 Short Ctr : 0
    Operating Mode : 31 Detect Enabled : YES

    Port 1 (channel 1): selftest = FAILED
    pongEnable = 0, legacyEnable = 0
    detEnable = 0, classEnable = 0
    hpEnable = 0, portStatus = 0
    detectStatus = 0, classStatus = -1
    operMode = 0, disconnectMode = 0
    iCutRange = 0, rDis = 0
    class4(2-evt) = 0, FET status = 0
    iCut = 0, iLimit = 0
    Voltage(dV) = 0, current(mA) = 0, power(mW) = 0