Wireless Access

 View Only
last person joined: 14 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP-605H - 6 GHz will not activate (8.12.0)

This thread has been viewed 10 times

  • 1.  AP-605H - 6 GHz will not activate (8.12.0)

    Posted 6 days ago

    We are installing a number of AP-605Hs.  Running 8.12.0.  We know that we can only uses 2 of the 3 bands, but we have been unable to get 6GHz to activate even if we turn off both 2.4 and 5.  What are we missing?  Thanks in advance.



    ------------------------------
    Rob Jones
    Vice President
    Bell IT Services
    rob@bellit.net
    ------------------------------


  • 2.  RE: AP-605H - 6 GHz will not activate (8.12.0)

    EMPLOYEE
    Posted 3 days ago

    When you configure a new WLAN, you need to enable it for 6G

    configuration -> Networks -> show adv options ->under 801.11



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: AP-605H - 6 GHz will not activate (8.12.0)

    EMPLOYEE
    Posted 3 days ago

    Items to verify:

    1. AP flex band configuration is set to allow 6 GHz.
    2. 6 GHz is enabled for the WLAN.
    3. WLAN is configured for WPA3, with or without transition mode.
    4. The DRT shows support for 6 GHz on the AP-605H in the regulatory domain used.


    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------

    Original Message