Hi Aruyap thank you for getting back.
Code snippets of the IGMP Configurations,
Switch 1 ( querier )
vlan 40
name security
ip igmp snooping enable
interface 1/1/48
description Dante System
no shutdown
vlan trunk native 40
vlan trunk allowed all
ip igmp snooping fastleave vlan 40
interface vlan 40
ip address 10.113.132.2/24
ip igmp enable
ip igmp version 2
ip igmp querier interval 5
ip igmp robustness 5
ip igmp last-member-query-interval 2
ip igmp query-max-response-time 50
ip igmp static-group 239.254.3.3
ip igmp static-group 239.255.255.255
//Outputs
IGMP group information for group 239.254.3.3
Interface Name : vlan40
VRF Name : default
Group Address : 239.254.3.3
Last Reporter :
V1 V2 Sources Sources
Vers Mode Uptime Expires Timer Timer Forwarded Blocked
---- ---- --------- --------- --------- --------- --------- --------
IGMP group information for group 239.255.255.255
Interface Name : vlan40
VRF Name : default
Group Address : 239.255.255.255
Last Reporter : 10.113.132.15
V1 V2 Sources Sources
Vers Mode Uptime Expires Timer Timer Forwarded Blocked
---- ---- --------- --------- --------- --------- --------- --------
2 2h 29m 0m 35s
Switch 2
vlan 40
name security
ip igmp snooping enable
ip igmp snooping version 2
interface 1/1/18
no shutdown
vlan trunk native 40
vlan trunk allowed all
ip igmp snooping forward vlan 40
ip igmp snooping fastleave vlan 40
interface vlan 40
ip igmp enable
ip igmp version 2
no ip igmp querier
ip igmp robustness 5
ip igmp last-member-query-interval 2
ip igmp query-max-response-time 50
Original Message:
Sent: Apr 09, 2024 08:22 PM
From: ariyap
Subject: ARUBA CX Switch + Dante Audinate Configuration
whats the the switch config for it? have you enabled IGMP snooping ?
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
Original Message:
Sent: Apr 09, 2024 05:38 AM
From: d4
Subject: ARUBA CX Switch + Dante Audinate Configuration
I have been having issues discovering Dante devices in the Dante Controller software.
Our network consists of a CX 6200 Stack and CX 6100 edge switches.
L3 routing happens on the 6200 stack with a seperate vlan dedicated to the Dante network. Dante devices get IP addresses and ping request work to them both on that vlan and others.
I have been through and done the Multicast setup's ( hopefully correctly) and can see multicast groups being established on that vlan.
When directly connected to a switch with a Dante box on the same vlan, Dante Controller can discover that device, but no others on the network.
Any thoughts on where I could be going wrong? is the mdns-sd blocking the discover? any example configurations?
Thank you in advanced.