Hi! I believe this is the wrong Forum's discussion section (IoT) to ask for ArubaOS-CX help (you risk your thread will pass unnoticed), better to eventually open this thread on the Wired Intelligent Edge section for better visibility.
By the way, if your ArubaOS-CX version is enough recent (say newer than 10.03...and it should be that, newer than 10.05, at least) the
command interface 1/1/1-1/1/4
should work projecting you into the
config-if
context for the indicated range (1/1/1-1/1/4), at that point you can specify the
vlan access
option for that range, example:
cx# config
cx(config)# interface 1/1/1-1/1/4
cx(config-if-<1/1/1-1/1/4>)# vlan access
<1-4094> VLAN identifier
cx(config-if-<1/1/1-1/1/4>)# vlan access 20
Give it a try!
Original Message:
Sent: Sep 07, 2022 02:30 PM
From: Brent Harding
Subject: ArubaOS-CX
I have been working with ArubaOS/ProVision for a while and I am just deploying my first ArubaOS-CX switch.
In ArubaOS to untag VLAN 80 on port 1-24 I would do the commands below.
config
vlan 80
untagged 1-24
Can you set the access VLAN on multiple ports like this at once or does it have to be one at a time like this?
config
interface 1/1/1
vlan access 80
interface 1/1/2
vlan access 80
interface 1/1/3
vlan access 80
interface 1/1/4
vlan access 80
and so on.......
Am I going about this the wrong way or missing something?