Have not seen that... did you get any further with TAC already?
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Feb 01, 2024 02:36 PM
From: dankingdon
Subject: CX port status taking hours or days to update in central?
I have an open support case for this already but thought I would share here to see if I can get any faster traction.
I am in the process of building a proof of concept for our network, 2x 8320, 3x 6200 cx switches.
The biggest issue I have so far is that changes to port statuses are taking absolutely ages to update in central. I can unplug a port and it still shows as up 24 hours later in the UI. The same happens if I plug a cable in. It shows as down for ages, despite central still receiving and showing usage stats for that port!
I've already checked firewall for blocked packets, checked the switches are all connected via show aruba-central and all seems fine.
Config changes are being pushed mostly within a few minutes to and from central. I can even disable an interface using the cli on the switch and the config will be updated in central within minutes, but the port status will still show as up/enabled.
Has anyone encountered this behavior before or is there a detailed guide on troubleshooting central connection issues? Something critical must not be reliably getting through from the switches to central.
Thanks in advance.