Hi,
Previously we used the 2530, now we have the 6000.
In the 2530 we would use the webinterface -> interfaces -> vlans ->
and enabled DHCP/Boop under the IP Config under each VLAN, so we could easily verify if DHCP correctly configured before connecting client devices.
Now i can't seem to find this option on the 6000.
After looking at the documentation https://www.arubanetworks.com/techdocs/AOS-CX/10.10/PDF/cli_6000-6100.pdf
I have found i can do this with the commands:
interface vlan x
ip dhcp
but then i get a prompt: "ip dhcp" is supported only on default vlan (vlan1)
So i suppose i can do it but only for 1 vlan at a time?
So there is no way like there was previously to enable dhcp for all vlans on the switch and see if all VLANs can receive an IP?
Arubanetworks |
remove preview |
|