I had an issue previously where AP305C did not connect at AT power from HP Procurve 2920
The solution was:
https://ewouddenbreeijen.nl/net-posts/poe-issues-aruba-switches-and-powered-device/
no lldp config <interface(s)> dot3TlvEnable poeplus_config
I now have same APs connected to Aruba 6300M (which is running very different OS, Aruba CX, so the commands are totally different)
Same issue:
MB-LG-DH-Mid#sh system led
Brightness configuration: soft
System LED status:
No Led Colour Blinking
---------------------------------------------------------
1 Power Off No blinking
2 Status White Slow blinking
https://extreme-networks.my.site.com/ExtrArticleDetail?an=000072411
White, Slow-blinking: The device has a CAPWAP connection to ExtremeCloud IQ, but is operating on 802.3af power instead of 802.3at power.
MB-LG-DH-Mid#sh system power mode
System Power Mode: Auto/AF
MAX tx/rx chains: 4X4
MAX wifi0 tx power: 20dbm
MAX wifi1 tx power: 20dbm
USB Port: On
GE Status
---------------------------
Eth0 UP
The PoE info from the switch
sw-flowerroom-6300(config)# sh running-config interface 1/1/10
interface 1/1/10
no shutdown
no routing
vlan trunk native 501
vlan trunk allowed 21,50,100,110,120,130,140,150,300
power-over-ethernet assigned-class 4
exit
sw-flowerroom-6300(config)# sh power-over-ethernet 1/1/10
Status and Configuration Information for port 1/1/10
Power Enable : Yes PD signature : single
PoE Port Status : delivering PD Type : Type2
Alloc-by Configured : usage Alloc-by Actual : lldp-dot3
User Profile Priority : N/A Port Config Priority : Low
Port Priority : low Pre-std Detect : Disabled
PD Requested Class : Class4 PSE Assigned Class : Class4
Fault Status : None User set Assigned Class : class4
PD Class Override : Disabled Power Pairs Configured : alt-a-and-alt-b
Power Pairs Applied : alt-a-and-alt-b
PoE Counter Information
Over Current Cnt : 0 MPS Absent Cnt : 3
Power Denied Cnt : 0 Short Cnt : 0
Power Information
PSE Voltage : 54.48 V PSE Reserved power : 16.80 W
PD Current Draw : 0.10 A PD Power Draw : 5.45 W
PD Average Power Draw : 4.88 W PD Peak Power Draw : 5.45 W
LLDP Information
MED Override : Disabled
MED Priority : Critical
PSE TLV Configured : dot3/med
PSE TLV Sent Type : dot3
PD TLV Sent Type : dot3
PSE Allocated Power Value: 15.40 W
PD Requested Power Value : 15.40 W
Any idea how to make the two of them living in harmony?
Thanks
------------------------------
spgsitsupport
------------------------------