Try using vlan level
switch(config)#
vlan 187switch(config-vlan)#
ip igmp snooping enableThe interface level config with blocked options seems to only drop incoming traffic
8360-1(config-if)# ip igmp snooping
blocked Instruct the device to drop incoming multicast traffic received on the specified ports on a VLAN
------------------------------
DWan
------------------------------
Original Message:
Sent: Dec 01, 2022 09:10 AM
From: Garet Huston
Subject: Multicast Traffic Flowing Across Uplink
We have an access layer 6300 switch stack that has hundreds of AV devices using multicast connected to it (all on VLAN 187). The IGMP querier lives on this access layer 6300. There is a layer 2 trunk from the access layer to our distribution 8320. Currently, this multicast traffic is climbing up to the distribution layer and causing some discards. I'm trying to prevent this multicast traffic from flowing across the trunk but want to allow unicast traffic across the trunk. I currently have the below commands placed on both sides of the trunk between the 6300 and 8320. The igmp snooping blocked command is not operating as I intended.
I also realize this is not the preferred way to perform a multicast boundary, however, I have not been able to convince my team to perform a network overhaul and move to L3 connections.
(6300 stack)
interface lag 10
description UplinkTo8320Stack
no shutdown
no routing
vlan trunk native 1
vlan trunk allowed 7,39,47,63,72,87,95,111,119,127,151,157,167,175,185-187,199-200,202-207,215,223,239,247,255,2063
lacp mode active
ip igmp snooping blocked vlan 187
(8320)
interface lag 112 multi-chassis
description UplinkTo6300Stack
no shutdown
no routing
vlan trunk native 1
vlan trunk allowed 7,39,47,72,87,95,111,119,127,151,157,167,175,185-187,199-200,202-206,215,223,231,239,247,255,2063
lacp mode active
ip igmp snooping blocked vlan 187