I have an HPE Aruba 2930F JL259A switch which is used to try out SDN related experiments. But after the aggregate mode instance is enabled , the ping command does not work. It results in "Request timeout out" response.
Aruba-2930F-24G-4SFP(config)# show VLANS
Status and Counters - VLAN Information
Maximum VLANs to support : 256
Primary VLAN : DEFAULT_VLAN
Management VLAN : DEFAULT_VLAN
VLAN ID Name | Status Voice Jumbo
------- -------------------------------- + ---------- ----- -----
1 DEFAULT_VLAN | Port-based No No
2 OF_CONTROLLER_VLAN | Port-based No No
3 OF_HOST_VLAN | Port-based No No
1. DEFAULT_VLAN (Primary VLAN) - Ports 1-6, IP Address 192.168.10.3 (Default IP: 192.168.10.1 for all three VLANs)
2. OF_CONTROLLER_VLAN - Ports 7-12, IP Address 192.168.11.1
3. OF_HOST_VLAN - Ports 13-28, IP Address 192.168.12.1
Aruba-2930F-24G-4SFP(config)# show openflow instance aggregate
Configured OF Version : 1.3
Negotiated OF Version : 1.3
Instance Name : aggregate
Data-path Description : aggregate
Administrator Status : Enabled
Member List : VLAN 3
Pipeline Model : Standard Match
Listen Port : None
Operational Status : Up
Operational Status Reason : NA
Datapath ID : 0003187a3b34dee0
Mode : Active
Flow Location : Hardware and Software
No. of Hardware Flows : 2
No. of Software Flows : 1
Hardware Rate Limit : 0 kbps
Software Rate Limit : 100 pps
Conn. Interrupt Mode : Fail-Secure
Maximum Backoff Interval : 60 seconds
Probe Interval : 10 seconds
Hardware Table Miss Count : NA
No. of Software Flow Tables : 1
Egress Only Ports : None
Table Model : Policy Engine and Software
Source MAC Group Table : Disabled
Destination MAC Group Table : Disabled
Default Miss Action : Drop
Packet-In VLAN Tagging : Default
Controller Id Connection Status Connection State Secure Role
------------- ----------------- ---------------- ------ ------
1 Connected Active No Equal
I'm using the RYU controller, and the initial handshake connection and configuration from the RYU side with switch seems to working correctly.
Controller IP Address: 192.168.11.2
Aruba-2930F-24G-4SFP(config)# show run
Running configuration:
; JL259A Configuration Editor; Created on release #WC.16.10.0009
; Ver #14:67.6f.f8.1d.9b.3f.bf.bb.ef.7c.59.fc.6b.fb.9f.fc.ff.ff.37.ef:44
hostname "Aruba-2930F-24G-4SFP"
module 1 type jl259a
ip default-gateway 192.168.10.1
snmp-server community "public"
openflow
controller-id 1 ip 192.168.11.2 controller-interface vlan 2
instance aggregate
controller-id 1
version 1.3
enable
exit
enable
exit
vlan 1
name "DEFAULT_VLAN"
no untagged 7-28
untagged 1-6
ip address 192.168.10.3 255.255.255.0
ipv6 enable
ipv6 address autoconfig
ipv6 address dhcp full
exit
vlan 2
name "OF_CONTROLLER_VLAN"
untagged 7-12
ip address 192.168.11.1 255.255.255.0
ipv6 enable
ipv6 address autoconfig
exit
vlan 3
name "OF_HOST_VLAN"
untagged 13-28
ip address 192.168.12.1 255.255.255.0
ipv6 enable
ipv6 address autoconfig
exit
management-vlan 1
no tftp server
no autorun
no dhcp config-file-update
no dhcp image-file-update
password manager
Any idea/suggestion as to why this is happening and what can be done would be really helpful, thanks!