Recently I ran into the same issue: The current HPE Quickspecs mention RA-Guard for 6000 and 6100 but it's not implemented.
https://www.hpe.com/psnow/doc/a00021859enwIt's available on 2530, 2540 and 2930 but on CX only 6300 and 6400.
I opened a case at Aruba Support 2 weeks ago and they've send me a link to the feature-navigator which states that this feature is not available on 6000/6100.
They advised me to make a feature request via Innovation Zone, but I'm unable to access Innovation Zone, receiving some cryptic error message. Currently fighting with Aruba support again, how to get access.
HPE/Aruba doesn't really seem to be interested to correct the misleading information in the quickspecs.
Meanwhile you could try to block IPv6 RA with access-lists.
Henry
Original Message:
Sent: Jun 09, 2022 03:58 AM
From: Stephen Elliott
Subject: RA-Guard on CX6100?
Thanks for your replies and the heads-up that the QuickSpecs sheet is not to be trusted.
Unfortunately we've already bought 100 of the CX6100s for our edge and now can't implement this required feature.
Original Message:
Sent: Jun 09, 2022 02:13 AM
From: Ivan ivan.bondar@hpe.com
Subject: RA-Guard on CX6100?
Exactly, that was my point - the discrepancy between DS/Guides on one side and QuickSpecs on another side might be the cause of this confusion :)
------------------------------
Ivan Bondar
Original Message:
Sent: Jun 09, 2022 02:08 AM
From: Ariya Parsamanesh
Subject: RA-Guard on CX6100?
I would generally go with datasheet instead of quickspecs
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Jun 09, 2022 12:24 AM
From: Ivan ivan.bondar@hpe.com
Subject: RA-Guard on CX6100?
Hi Starsky,
I've checked IP Services Guides for the platform (for ver. 10.08 and 10.09), no mention of ND Snooping and/or RA Guard in particular. However the QuickSpecs for the 6100 promises this feature:
When there is a mismatch between the specs on one side and guides/actual CLI of the device on another side in 90% of cases it is a typo (or should I say a copy-paste problem) in the specs.
------------------------------
Ivan Bondar
Original Message:
Sent: Jun 08, 2022 07:28 PM
From: Ariya Parsamanesh
Subject: RA-Guard on CX6100?
I dont think this is supported on 6100, where did you see that it is supported in DS?
This is the extract from DS
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Jun 08, 2022 09:10 AM
From: Stephen Elliott
Subject: RA-Guard on CX6100?
How to enable RA-Guard on CX6100?
The datasheet says it can do it, but nothing in the Command Reference guide.
*nd-snooping doesn't seem to apply to the 6100 series