Thanks a lot Ian.
That worked.
Original Message:
Sent: Jan 13, 2024 06:21 AM
From: IanNightingale
Subject: Remove VRRP
Hi, for a comware device the VRRP is configured in the SVI (vlan interface).
So something like
sys
interface vlan 1
undo vrrp ..... (undo each vrrp command under the stanza)
Original Message:
Sent: Jan 09, 2024 09:19 AM
From: kabamaru
Subject: Remove VRRP
Hello everyone
I have a very old HP 3com switch 4800G, which still runs with no problems but the time has come to replace it. The switch has a VRRP configured for VLAN1. Does anyone know the syntax for removing it, please? I did have a look at the CLI reference for 3com online but I could only find the syntax to create a VRRP, couldn't see anything for removing it. Please see below
[3com]show vrrp
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
---------------------------------------------------------------------
Vlan1 1 Backup 110 1 SIMPLE 10.84.100.200
--------------------------------------------------------------------
How can I remove the above VRRP entry?
Thank you
Kabamaru