Hi all,
I'm having some issues getting my switch to sync time from the NTP server on my domain. We recently migrated the server to another DC due to a FSMO role change. I'm using a 2930F configured with NTP synchronization located in Central Time Zone. The time is off by about 23 minutes and I can't figure out why it is off. I have redacted the time server IP, but all other workstations and servers are using the server successfully on the network.
timesync ntp
no sntp
ntp unicast
ntp server x.x.x.x iburst
ntp enable
time daylight-time-rule continental-us-and-canada
time timezone -360
The current time is 9:54am 8/31/2022 and my switch is showing 9:31am 8/31/2022
CityHall-SW2# sh time
Wed Aug 31 09:31:17 2022
NTP Associations Entries
Remote St T When Poll Reach Delay Offset Dispersion
--------------- ---- ---- ------ ----- -------- -------- -------- ----------
x.x.x.x
4 u 5143 10 37777... 0.001 1389.603 0.30809
-My offset is showing 1389 seconds which is about 23 minutes of offset. I've read online that this offset will slowly be adjusted, however after 2 days there has been no change to the offset.
NTP Status
CityHall-SW2# sh ntp status
NTP Status Information
NTP Status : Enabled NTP Mode : Unicast
Synchronization Status : Synchronized Peer Dispersion : 0.30809 sec
Stratum Number : 16 Leap Direction : 0
Reference Assoc ID : 1 Clock Offset : 1389.60332 sec
Reference ID : x.x.x.x Root Delay : 0.03664 sec
Precision : 2**-18 Root Dispersion : 1186.00820 sec
NTP Up Time : 20d 18h 58m Time Resolution : 819 nsec
Drift : 0.00000 sec/sec
System Time : Wed Aug 31 09:35:01 2022
Reference Time : Sun Apr 10 00:25:35 2022
I am a rookie when it comes to configuring the NTP settings on an Aruba switch. Any advice would be truly appreciated as I'd like to get this configured on all of my switches correctly.