That's correct, you have to use different AP groups in this scenario. Glad you got it working.
Original Message:
Sent: May 07, 2024 11:53 AM
From: Ospon
Subject: Time range profiles
The caveat that I forgot to mention is the the SSID name needed to be the same.
I had tried something similiar as what you suggested earlier but ran into the issue that it complained about duplicate SSID.
However with your help I managed to figure out that it wasn't that I 'couldn't created a duplicate SSID' it was rather that I 'couldn't have two VAP's with the same SSID name in one AP group'.
Thanks for the help :)
Original Message:
Sent: May 06, 2024 05:15 PM
From: schmelzle
Subject: Time range profiles
In the Virtual AP profile (System > Profiles > Wireless LAN) look for the "Deny time range" dropdown under the Advanced section in the UI (in the CLI it would be deny-time-range
) and select a range. You may have to create one if the two included default time ranges don't line up with what you want:
time-range periodic working-hours
Weekday 08:00 to 18:00
!
time-range periodic night-hours
Weekday 18:01 to 23:59
Weekday 00:00 to 07:59
!
If you're looking to have certain areas where guest is not disabled during non-business hours, you'll want to create and manage two VAPs for guest. One with the desired time range profile and one without. Then apply the respective VAPs to your target AP groups.
Original Message:
Sent: May 06, 2024 04:32 PM
From: Ospon
Subject: Time range profiles
Hello,
We are in the process of moving from an Instant environment managed by Airwave to a Controller based environment with Clearpass.
One thing that I found helpfull in Airwave was that I could set up Time Range profiles for certain sites that wanted the guest SSID to be turned off during non-business hours by applying it to that SSID on that instant-cluster.
I'm not really finding that it works the same way on the controller though.
I would like to only apply it to a SSID in a specific AP-group however it seems that SSID settings are global so the Time Range profile I try to set up is applied to the entire environment.
Is it possible to limit the scope or do I have to figured out a different way to do this ?
And if that is the case tips would be appreciated .