Good morning,
Any suggestions on configuration of a wired client with a wireless bridge. I am trying to setup these bridges to wirelessly connect some older wired only medical devices in our facility.
I have some older Aruba 501 Client Bridges which I am unable to get a stable connection on the wireless side, I am seeing the wireless connect and disconnect after some time client trail info shows unspecified error.
I also purchased some Ubiquiti NanoStation Loco M5 APs and am able to get them to work in router mode but not Bridge mode. The Ubiquiti bridges are stable on the wireless but the wired client continuously try to pull an IP and depletes the DHCP scope with BAD addresses.
I feel there is a setting in the VAP config that is killing multiple clients behind 1 wireless MAC or something security wise. I have the default setting on Max IP per wireless user of 2
I also have saw some saying that Convert ARP to Unicast needs turned off, it is on by default. I have adjusted this to off in the test lab with no changes on pulling DHCP through the wireless bridge or the 501 behavior.
I have a TAC case open on the original Aruba 501 issue but havent heard back. We are running 8.10.0.4 in the Lab.
Thanks,
Chris