09-22-2015 02:39 PM
I am having issues brining up a RAP. I have done the following things on the controller:
1- Created the RAP AP profile
2- Created the AP Group
3- Assigned the SSID
4- configure the NAT rule on the FW and allowed port UDP 4500 and TFTP 69
I think is caused because IAP to RAP conversion does not go through properly but I might be worng.When I convert the IAP to RAP..I dont get any sort of confirmation that its convereted to RAP. See the picture attached for detail. Once I get this error, I am not able to access the RAP through GUI and I am not sure whether the conversion was successful or not. I have tried connecitng my home router connection to the port 0 and then port 1 to my laptop but my laptop is getting APIPA address.
Any help will be apprecited. Thanks
09-22-2015 03:25 PM
on the controller:
config tlogging level debugging security subcat ike
logging level debugging security process aaa
logging level debugging security process authmgr
logging level debugging security subcat l2tp
logging level debugging security subcat vpn
Try to convert the RAP. When it fails, type "show log security 50" and paste in that log here as a response.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
09-23-2015 01:54 AM
Have you defined a NAT pool for the raps?
ip local pool <name> <start ip> <end ip>
If my post is helpful please give kudos, or mark as solved if it answers your post.
ACCP, ACMP, ACMX #294