Aruba Instant & Cloud Wi-Fi

Reply
Occasional Contributor II
Posts: 11
Registered: ‎06-27-2012

IAP-277 point-to-point bridge configuration

I need configuration examples of this solution and can not find, can anyone help me?

MVP
Posts: 4,124
Registered: ‎07-20-2011

Re: IAP-277 point-to-point bridge configuration

What you need to do is the following:
- Have both IAPs connected on the same VLAN so they can build a cluster.
- Once the cluster is build you should be able to disconnect the IAP you are planning to use as the Mesh point.
- If you only provide power to that IAP (NO NETWORK) then it should be able to build a mesh link automatically if the mesh point is able to build the link with the Mesh portal (IAP with Network connectivity)
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Aruba Employee
Posts: 1,253
Registered: ‎11-07-2008

Re: IAP-277 point-to-point bridge configuration

The above is correct. The antenna is wide enough that eye-balling the alignment should be fine. The Instant userguide also has steps on creating an instant mesh cluster.

Jerrod Howard
Sr. Techical Marketing Engineer
Occasional Contributor II
Posts: 11
Registered: ‎06-27-2012

Re: IAP-277 point-to-point bridge configuration

I tried but it is not working, sending solution scheme to be set.

thank you
,

Guru Elite
Posts: 20,424
Registered: ‎03-29-2007

Re: IAP-277 point-to-point bridge configuration

[ Edited ]

ccarrico,

 

The only thing not mentioned is that you would have to turn off (disable)  "Extended SSID" in the cluster before you remove the second Mesh AP http://community.arubanetworks.com/t5/Controller-less-WLANs/Aruba-Instant-4-1-Mesh-Configuration/ta-p/214943

 

extended.png



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: