06-13-2015 11:04 AM - edited 06-13-2015 11:17 AM
I have deployed virtual controller based soultion at different customer sites.
Customer 1: IAP model 104 solution containing more than 40 IAP.
Customer 2 : IAP model 103 solution containing more than 40 IAP.
Customer 3 : IAP model 103 solution containing more than 50 IAP.
Recently I have deployed virtual controller solution of IAP 103 (15 IAPs) at the customer site. Customer also wants to make the IAP-92 (3 iaps) to be a part of virtual controller solution. When I connect iap-92 aps, on the virtual controller total 16 accesss points are shown 15 (103) and one (92). The remaining two IAP-92 are properly power up/stable but not showing on the virtual controller. When I power off the two iaps of model 103 then the remaining two IAP-92 which were not showing previously are now showing on the controller.
What should i do to put all the iaps on the virtual controller?
How much IAPs are supported on the virtual controller? Are they should be of same model ??
Solved! Go to Solution.
06-13-2015 05:15 PM
IAP 92/93s cannot be part of a VC that has more than 16 APs. http://community.arubanetworks.com/t5/Aruba-Instan
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs