12-22-2011 10:56 AM
Good afternoon guys!
I´m new with aruba and i have a big problem with my IAPs 93. I made a reset_factory / purgeenv / save / boot and now i cannot access with admin/admin through console.
When i put the user and password via console it just request again. Besides that the instant wirelless network don´t appear so i cannot access via browser.
Could you please help me with this issue?
Thank you very much!
Solved! Go to Solution.
12-22-2011 11:14 AM
Did you try using the reset button on the AP?
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
12-22-2011 11:28 AM - edited 12-22-2011 11:35 AM
As suggested by colin , try the reset button. After that console into to the AP and notice the activities to see whether the AP is elected as the master, unless the IAP is elected as the master you cannot use the username/password to login to the console.
I hope you dont have another IAP on the same layer 2 that is acting as master. You can login only on to the IAP that is elected as master.
12-26-2011 08:32 PM
Please try setting up the IAP in a stand-alone network after resetting, see if it works.
If it stll does not, you can post the console output of the boot process, and one of us can check it to see if anything looks suspicious.