05-13-2013 05:07 PM
I'm running a cluster of IAP-105s using what I believe is currently the latest firmware (18.104.22.168-22.214.171.124_38115).
I have a misbehaving device somwhere in the building, and I'm trying to lock it out by manually blacklisting its MAC address in the "Blacklisting" tab of the "Security" settings. Adding the MAC address of the offending device seems to have no effect -- I continue to see it reconnect to the network and send packets.
Is there anything non-obvious about setting up manual blacklist entries?
Solved! Go to Solution.
05-13-2013 07:39 PM - edited 05-13-2013 07:40 PM
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
03-25-2014 06:46 PM
I'm running 126.96.36.199-188.8.131.52_42384 and have the same issue. Tested it out and see the device drop its wifi then connect up again. Blacklisting is not working as the device is still connected and can surf.
03-25-2014 06:51 PM
Can you see if it is listed in the blacklist http://www.arubanetworks.com/techdocs/Instant_40_W
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
04-09-2014 10:13 AM
Just back from holidays and looked into the config. I found that Blacklist was *not* enabled in the SSID. Set it up, rebooted the AP's and things are working as advertised. Thanks for you help on this. Would be nice to have a note in the Manual Blacklisting window to the user to "Ensure Blacklist is enabled in the SSID config" or an indication of the Blacklist state.