Aruba Instant & Cloud Wi-Fi

Reply
Occasional Contributor I
Posts: 7
Registered: ‎12-05-2012

VC not in "access point list"

I just upgraded my firmward to the lastest version for the IAP-105's. I have 10 deployed. 1 AP is not connecting to the VC and the VC AP is not showing as an AP in the Access Point list when looking at the preview window on the VC Access Point itself.  Although I can see the MAC name in the title bar that I am logged into the right VC, its only showing me 8- out -10 AP's. Two are missing not sure why. Any ideas

Guru Elite
Posts: 20,002
Registered: ‎03-29-2007

Re: VC not in "access point list"


j.pfahl wrote:

I just upgraded my firmward to the lastest version for the IAP-105's. I have 10 deployed. 1 AP is not connecting to the VC and the VC AP is not showing as an AP in the Access Point list when looking at the preview window on the VC Access Point itself.  Although I can see the MAC name in the title bar that I am logged into the right VC, its only showing me 8- out -10 AP's. Two are missing not sure why. Any ideas


Did they ever all work at the same time?  Do you have a VC address configured?  Are they all in the same VLAN (I know...obvious question, but I have to ask)...

 

Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Occasional Contributor I
Posts: 7
Registered: ‎12-05-2012

Re: VC not in "access point list"

Yes you bet. I have been online with 9-of-10 AP's. VC has a DHCP network assigned IP. My 10th AP, the last one installed 2 weeks after the inital install never did show up on the VC. Prior to the firmware upgrade the system seemed to be working well and correctly.  In fact, when i logged into the VC gui- the column that lists your AP's, listed my VC in that list too. That way, obviously, I can click on it for device details.  Im not sure why the 10th AP never did appear in that list, autojoin enabled.

 

yesterday I did a firmware upgrade. It said that it was successful, rebooted all machines. When they rebooted, I had to turn them all off again, turn on the VC that was the VC before, first. Then I turned on all the rest. The 10th AP still is not listed and the VC AP is not listed. However, I know that I am logged into it because it shows its' name at the top.

 

I just wasn't sure if the firware upgrade had anything to do with this. Seems to me that it should still be listed there. I never changed the VLAN's but I can go check that. Have to figure out how. I suppose I have to console into the 10th AP since it is not listed in the GUI. The VC can obviously see 8 of the AP's as they are in the list.

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: