08-22-2014 06:36 AM
Can I have more than one AP Group in a single Virtual Controller?
I would like to have 2 differents AP Groups in the same Virtual Controller. Is it possible?
Solved! Go to Solution.
08-22-2014 06:39 AM - edited 08-22-2014 07:26 AM
Are you running 4.1?
If so, you can use the new zones feature which would be similar to a controller AP group.
From the 4.1 User Guide (page 84):
All APs in a cluster use the same SSID configuration including master and slave IAPs. However, if you want to assign an SSID to a specific IAP, you can configure zone settings for an IAP.
The following constraints apply to the AP zone configuration:
- An IAP can belong to only one zone and only one zone can be configured on an SSID.
- If an SSID belongs to a zone, all IAPs in this zone can broadcast this SSID. If no IAP belongs to the zone configured on the SSID, the SSID is not broadcast.
- If an SSID does not belong to any zone, all IAPs can broadcast this SSID. You can add an AP zone by through the UI or CLI.
Tim Cappalli | Aruba ClearPass TME
@timcappalli | ACMX #367 / ACCX #480 / ACEAP / CWSP