09-19-2012 07:41 PM - last edited on 05-30-2014 07:28 AM by Jamie E
I try changing the IP adress of my Instant93 through CLI. I telnet to the ap and send the following commands
setenv ipaddr 10.0.1.255
exit wr mem
But it does not work.Is there any suggestion?
Thank you guys so much
Solved! Go to Solution.
09-19-2012 10:28 PM
You are in the bootloader which is way before the IAP SW loads.
Configuration in Instant is intened to be done via the WebUI. To change the IP address of the Instant VC in the WebUI go to Settings > General > Virtual Controller IP.
You can also go in via the console port or Telnet after enabling "Terminal Access" and set the VC IP using the CLI command "virtual-controller-ip <addr>
09-20-2012 02:43 PM
The virtual IP address is assign to the Instant Cluster. The IP address will be active on the Virtual Controller.
If you want to change the IP address on a specific IAP.
1. Select the IAP -> Click on Edit -> Click on "Specify Statically" then fill in the IP Address, Subnet , Gateway, DNS in the text box
2. Reboot the IAP
09-23-2012 08:21 PM
Thanks for your reply. Marcus. But what I want to change is the master address. Is there any suggestion
In Instant Virtual Controller (VC) = Master. I listed the syntax to change the VC IP in my first post. By hard-setting this address whomever is acting to the VC will respond on that IP.
The CLI is not officially supported in Instant and there is no published CLI reference guide. The WebUI is the best way.